Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/2016 43
5.16Operating the edge cutter
The lowering and raising of the edge cutter is defined via the
parameter settings in the controller.
Read the  Operating manual for the DAC classic or DAC basic
controller for information on this. The operating manual for the
controller is provided in the accessory pack delivered with the
controller.
The operating manual for the controller is also available in the
download area at www.duerkopp-adler.com.
The cutting speed of the edge cutter is defined via a 3-position
switch. The positioning of the switch depends on whether or not
the DAC mini controller is used.
5.16.1 Setting the edge cutter without a DAC mini
On machines without a DAC mini the switch (3) for the edge cutter
is located on the machine arm. The LED (4) lights up green when
the machine is switched on.
Figure 24: Setting the edge cutter without a DAC mini
Setting the edge cutter without a DAC mini
1. Set the switch (3) to the desired position:
• Switch off the edge cutter: Position 0
LEDs (1) and (2) are off.
• Low speed: Position I
(for small to medium stitch lengths)
• High speed: Position II
(for medium to large stitch lengths)
 After moving the switch (3) to position I or II the LED (2)
flashes. At the start of sewing the edge cutter switches on
automatically after the 1st stitch. The LEDs (1) and (2) light
up constantly while the edge cutter is working.
①③
(1) - Edge cutter LED
(2) - Edge cutter LED
(3) - Edge cutter switch
(4) - Machine on/off LED
④②