Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/201638
5.11 Limiting the upper transport length
Certain equipment ( Sewing equipment parts list) requires the
maximum upper transport length to be limited to a value less than
8 mm. The limiter (1) for this is supplied with the corresponding
sewing equipment.
Figure 19: Limiting the upper transport length
Setting the limiter for maximum upper transport length
1. Complete the assembly of the limiter (1) with washer and
screw.
2. Insert the limiter (1) into the slot and turn by 90°.
3. Slide the limiter (1) to the value on the scale corresponding to
the maximum upper transport length for the sewing equipment
being used.
4. Screw the limiter (1) tight at the desired position with the screw.
①
(1) - Limiter