Operation Manual

Operation
Operating manual 275 Version 01.0 - 01/2016 25
5.4 Inserting and winding on the hook thread
1. Fit the thread reel onto the thread stand ( page 22).
2. Insert the thread from the rear to the front through a hole in
the guide on the unwinding bracket.
Important: The unwinding bracket must be parallel to the
thread stand.
Figure 7: Winding on the hook thread - part 1
3. Fit the empty bobbin onto the bobbin shaft (3).
4. Insert the thread from the right to the left through the thread
guide (2).
5. Guide the thread clockwise around the gap in the hook thread
winding tensioner (1).
6. Wind some of the thread clockwise onto the bobbin.
7. Pull the thread through the cutting clamp (4) and cut it off after
this.
8. Press the bobbin winder flap (5) against the bobbin.
9. Switch on the machine.
Risk of injury from moving parts.
Switch off the sewing machine before inserting the
thread.
WARNING
(1) - Bobbin thread winding tension
(2) - Thread guide
(3) - Bobbin shaft
(4) - Cutting clamp
(5) - Bobbin winder flap
①②
③
④
⑤