Instruction manual

Key Function Display
7 basic needle position = down left arrow above the key on
basic needle position = up right arrow above the key on
8 residual-thread monitor on xxxx - - I I - -
the function of the residual-thread monitor
can be changed with the parameter 195
(see Efka parameter list)
9 function key
the function of the key can be changed with
parameter F-008 (see parameter list,
section 7.1.3)
1 = Softstart ON/OFF SSt ON*/OFF < — > SSc xxx
2 = ornamental-stitch bar tack ON/OFF SrS ON*/OFF
3 = stroke adjustment hPr ON*/OFF
function of the knee-switch or key:
“press and release” = ON /
“ press and hold” = OFF
4 = needle cooling ON/OFF nh ON*/OFF
* when ON the left arrow above
the key is switched on
0 teach in or program number
run the saved sewing program seam-section number
see programming instructions in the operating seam-section stitch number
instructions
EFKA DA220C 5300 number of stitches after
light-barrier detection
A suppress or invoke bar tacks no display
if the starting or ending bar tack is switched on,
pressing the key switches the next bar tack off
if the starting or ending bar tack is switched off,
pressing the key switches the next bar tack on
B needle up/down no display
or Shift function in programming mode
pressing this key executes a needle movement
that can be programmed with parameter 140.
See the Efka parameter list. In programming
mode this key has a different function.
See section 7.3.8
P programming mode on/on parameter number/standard display
see sections 7.3.4 and 7.3.7
E switch from parameter number to parameter number/parameter value
parameter value.
Confirm parameter value and
switch to next parameter.
See sections 7.3.4 and 7.3.7
+ increase the value displayed displayed value is increased
in programming mode
- reduce the value displayed displayed value is reduced
in programming mode
42