Instruction manual

7.2.6 Changing technician-level and manufacturer-level parameter values with
the V810 operating panel
Entering the technician-level code
–
Turn off the main switch.
–
All plugs on the sewing-drive control must be plugged in.
–
Press and hold down the “P”key.
–
Turn on the main switch: “C-0000” appears in the display.
–
Release the “P”key.
–
Enter code 1907.Pressthe“+”or“-” keys to change the value of the flashing
figure. Press the “>>” key to move to the next figure.
–
Press the “E” key: the first technician-level parameter, “F-100”, is displayed.
Selecting parameters and changing values
–
Press the “+”or“-” keys to select the next or previous parameter.
–
Parameters can be directly entered with the “>>”, “+”or“-”keys.
–
Press the “E” key: the value of the selected parameter is displayed.
–
Press the “+”or“-” keys to change the value of the parameter.
–
Press the “E” key to display the next parameter or key “P” to display the same
parameter.
Saving changed parameter values
–
Press the “P” key to end programming.
–
Sew a complete seam by pushing the pedal forwards and then all the way back.
The change is saved.
–
If no seam is sewn, the change is lost.
–
Press the “P” key again to return to the programming level.
Entering the manufacturer-level code
–
Turn off the main switch.
–
All plugs on the sewing-drive control must be plugged in.
–
Press and hold down the “P”key.
–
Turn on the main switch: “C-0000” appears in the display.
–
Release the “P”key.
–
Enter code 3112.Pressthe“+”or“-” keys to change the value of the flashing
figure. Press the “>>“ key to move to the next figure.
–
Press the “E” key: the first manufacturer-level parameter, F-200, is displayed.
–
Continue as described under “Selecting parameters and changing values”.
38