Instruction manual

5.3.2 Subclass 275-742642

With this subclass a large number of assemblies are fitted under the table top, so it is

essential to comply with the dimensional sketch in section 3.2.3.

–

Screw on the bracket 2 under the table top 5 (see illustration above right).

–

Screw the set-point generator 3 onto the bracket 2 (see illustration above right).

5.4 Fitting the knee-switch

5.4.1 All subclasses except 275-742642

–

Screw on the knee-switch 7 under the table top (illustration above left).

5.4.2 Subclass 275-742642

–

Screw on the knee-switch 7 under the table top (illustration above right).

5.5 Fitting the cable conduit

–

Screw on the cable conduit 1 under the table top 5.

5.6 Fitting the pedal

–

Attach the pedal 10 to the frame brace 11.

–

For ergonomic reasons the lateral alignment of the pedal 10 should be such that

the middle of the pedal is roughly beneath the needle.

The frame brace 11 is fitted with slots for pedal alignment.

–

Attach the pedal linkage 9 with ball sockets to the set-point generator 3 and

pedal 10.

–

Slightly undo screw 4.

–

Adjust the height of the pedal linkage:

when not under load the pedal must be at an angle of approx. 10°.

–

Tighten screw 4.