Instruction manual

3.2.2 Machines with an edge cutter

(classes 275-740642 and 275-742642)

–

Fit the top support 15 into the hole in the table plate.

–

Fit the rubber rests 14 for the upper part of the machine into the recesses in the

table plate 12.

–

Fit the rest plug 13 and push on the pressure springs.

–

Screw on the drawer 11 with its brackets under the left-hand side of the table plate.

–

Screw on the cable conduit 10 under the back of the table plate.

–

Mark the positions of the screw connections of the oil drip pan 2 and fix it under the

table-plate opening with wood screws.

–

Mark the positions of the screw connections of the waste chute 16 and attach it

under the table-plate opening with wood screws.

Screw the oil drip pan 2 and waste chute together.

–

Attach the table plate 12 to the frame with wood screws (B8 x 35).

Its position on the frame can be seen from the dimensions in the sketch

(see page 9).

–

Fit the reel stand 1 into the hole in the table plate and attach with nuts and

washers.

Fit and align the yarn-reel holder and thread-guide arm.

The yarn-reel holder and thread-guide arm must be vertically aligned.