Instruction manual

Sewing operation operation / explanation
In mid-seam
Interrupting sewing
Sewing a corner
Fullness facility
(275-140332, -140342, -740642)
Fullness facility
(275-142342, -742642)
Continuing sewing
(after releasing the pedal)
Sewing an intermediate bar tack
- Release pedal (neutral position).
The machine halts in position 1
(needle down).
The sewing feet are down.
- Push pedal half-way back.
The machine halts in position 1
(needle down).
The sewing feet are raised.
- Rotate the material round the needle.
- Press key 3.
The fullness facility is in line with the
values set.
- Press key 3 again.
Sewing continues without fullness.
See section 6.18.4
- Push pedal forwards.
The machine sews at the speed
set by the pedal.
The s tar t i ng b ar tac k i s not sewn.
- Press key 2 and hold the pedal down.
The machine sews backwards for as long
as key 2 is held down.
The speed is determined by the pedal.
At the seam-end
Ending the seam
Ending the seam
with no ending bar tack
- Push pedal fully back and hold it there.
The ending bar tack is sewn.
The thread is cut.
The machine halts in position 2.
The sewing feet are raised.
Remove material.
- Press key 1 (suppress bar tacks).
Push pedal fully back.
The ending bar tack is not sewn.
The thread is cut.
The machine halts in position 2.
The position of the sewing feet depends
on the position of the pedal:
a) hold pedal back:
- sewing feet raised
b) pedal released (neutral position):
- sewing feet down.
31
GB