Instruction manual

6.18.4.2 Sew ing w ith fullness
When the machine is switched on press one of the keys from 1 to 8 (e.g. key 1): fullness
sequence 1 is activated and the green LED above key 1 lights up. All other fullness
sequences (e.g. from 2 to 8) must be deactivated (the red LEDs must light up). The
procedure is as follows:
–
press and hold down the on/off key
–
briefly press all the keys of the fullness sequences that are not required
(e.g. from 2 to 8) one after the other
–
as each key is pressed the red LED above it is s witched on
–
pressing a key again reactivates the sequence, and the red LED goes out
–
release the on/off key
–
The current overfeed length of the acti ve fullness sequence is shown in the display.
If the result is not satisfactory, the overfeed length can be changed with the +/- keys
until a satisfactory result is obtained. The altered overfeed-length setting is immediately
saved.
6.18.4.3 Sw itching between smooth sew ing and fullness
If you wish to keep switching between smooth sewing and fullness, proceed as follows:
–
Simultaneously press the “smooth sewing” key and the required fullness key
(key 1 to 8). The green LEDs above both k eys light up.
–
The switch between smooth sewing and the activated fullness takes place when the
knee switch is operated or when the thread is cut (see also section 6.18.5 ).
Pressing the “smooth sewing” key switches this work mode off again.
6.18.4.4 Sew ing w ith 8 programmed fullness sequences
When the machine is switched on the l ast fullness program to be used is briefly
displayed and activated. The green LED above the current fullness sequence lights up.
If this does not happen, the required sequence must be switched on by pressing the
key. The applicable overfeed length is shown in the display. After the first fullness
sequence has been sewn the next sequence is activated by operating the knee switch
or when the thread is cut (see also section 6.18.5 ).
If the required fullness i n a sequence is not obtained, the overfeed length be changed
by pressing the +/- keys. If the next sequence is then switched on, the change is saved.
After the 8th fullness sequence c ontrol passes automatically to the 1st fullness
sequence.
Sewing with less than 8 programmed fullness sequences.
If less than 8 fullness sequences are required in a seam, the fullness sequences not
required must be deactivated. The procedure is as follows:
–
press and hold down the on/off key
–
briefly press all the keys of the fullness sequences that are not required
one after the other
–
as each key is pressed the red LED above it is s witched on
–
pressing a key again reactivates the sequence, and the red LED goes out
–
release the on/off key.
27
GB