Instruction manual

6.18 Fullness control (Cl. 275-142342, 275-742642)

6.18.1. General

This fullness control permits the “semi-automatic” processing of various fullnesses

within a s eam. 30 programs with up to 8 s equences each can be stored. In each

sequence the set length of the overfeed is shown in the display, and it can be changed

manually at any time. Operating the knee switch moves from one sequence to the next;

this happens automatically at the end of a seam when the thread is cut.

6.18.2. Operating terminal - description of the operating components

“Smooth-sew ing” key

When this key is operated the green LED above the key

lights up and the material is “smooth-sewn”, i.e. with no

gathering. The length of the overfeed must be set (with the

+/- keys) so that the material is sewn with no gathering.

Keys 1 to 8 “sequence”

With the keys 1 to 8 the required sequence within a

program can be directly switched on. The LEDs above the

keys display the following states:

green LED on = current sequence

red LED on = inactive sequence

both LEDs off = active sequence

both LEDs on = this current sequence was switched on

manually. It is skipped in the sequence advance.