Instruction manual

Not automatically sw itching off the edge cutter at the seam-end
If parameter 256 = 0, the edge cutter is not automatically switched off at the seam-end.
It can only be switched on and off again by pressing the Y key.
6.16.2 Sw itching on the edge cutter w ith an automatic delay
If in each seam the edge cutter is to be switched on with a delay, i.e. after a certain
number of stitches, the parameter 258 must contain this number of stitches. In this case
the edge cutter is switched on once that number of stitches has been sewn since the
start of the seam. During the stitch count LED X flashes. Pressing the Y key s witches
the edge cutter on immediately, the stitch count is terminated and LED X is permanently
on.
All other functions are as described in section 6.16.1.
6.16.3 Sw itching on the edge cutter manually
If the edge cutter is always to be switched on manually, never automatically, the number
of stitches in parameter 258 must be set to 0. The edge cutter can then be switched on
and off with the Y k ey at any time, even with the machine at a standstill.
All other functions are as described in section 6.16.1.
6.16.4 Sw itching off the edge cutter automatically, by stitch count
If the edge cutter is only to be switched on for a certain number of stitches, this number
can be entered in parameter 259. Counting begins when the edge cutter is switched on.
During the stitch count the edge cutter can immediately be switched off by pressing the
Y key, which terminates the stitch count.
22