Instruction manual

6.16 Edge cutter (Cl. 275-740642)

6.16.1 Automatically sw itching on the edge cutter w ith the first stitch

The sewing-drive control contains a function module to raise and lower the edge cutter.

Its parameters must be set as follows:

Function parameter

Function module B “edge cutter: automatic” 255 = 9

Edge cutter switched off when the thread is cut 256 = 1

Stitch number for automatic switch-on 258 = 1

Stitch number for automatic switch-off 259 = 0

(for setting the parameters see Set-up instructions, s ections 7.1.4, 7.2.6, 7.3.7)

Selecting the cutting speed

The control for the cutting speed of the edge cutter is switched on with the

three-position switch 3.

Position 0 = edge cutter off. LED 2 is off.

Position I = low cutting speed for small to medium stitch lengths.

Position II = high c utting speed fo r medium to large stitch lengths.

When the switch 3 is in positions I and II, LED 2 flashes.

The green LED 4 lights up when the machine is switched on.

When the seam is commenced the edge cutter automatically switches on after the first

stitch. LEDs 2 and X are permanently on when the edge cutter is running.

Automatically sw itching off the edge cutter at the seam-end

If parameter 256 = 1 the edge cutter is automatically switched off at the seam-end when

the thread is cut. The edge cutter can also be switched on and off again at any time by

pressing the Y key.

YX 2 3 4