Instruction manual

6.14 Setting the value of the overfeed (fullness)

(275-140332, 275-140342, 275-740642)

If the stitch length for forward sewing is changed with adjustment wheel 1, the overfeed

is automatically changed in line with it.

The overfeed length is adjusted with adjustment wheel 6 and can be read off

at pointer 3.

When using the mechanically or electropneum atically connectable fullness facility

(optional extra), the maximum overfeed length can be limited using handle 4. The

maximum overfeed length is displayed by pointer 2.

The function for the electropneumatically connec table fullness facility (optional extra) is

incorporated in the sewing-drive control.

6.15 Limit on overfeed length

(275-140332, 275-140342, 275-740642)

When using some equipment the maximum possible overfeed length applies (see parts

list, sewing equipment). The overfeed-length limiter 5 is supplied together with the

relevant equipment.

The limiter is fitted as follows:

–

Fit the washer and screw to the limiter 5.

–

Insert the limiter 5 in the slit and rotate by 90°.

Adjust the position of the limiter in the slit so that the pointer 2 cannot be

shifted beyond the maximum permissible overfeed length (see parts list,

sewing equipment).

–

Tighten screw.