Instruction manual

6.5 Fitting the hook thread bobbin

Caution: danger of injury

Turn off the main switch.

The hook thread bobbin may only be fitted with the machine

turned off.

Removing the bobbin

–

Raise the bobbin-housing flap 1.

–

Remove the bobbin-housing top 2 with the bobbin.

–

Remove the empty bobbin from the bobbin-housing top 2.

Fitting the full bobbin

–

Place the full bobbin 3 in the bobbin-housing top 2.

–

Pull the hook thread through slit 4 under tension spring 6 and into hole 5.

–

Pull about 5 cm of hook thread out of bobbin-housing top 2.

When the thread is pulled out the bobbin must rotate in the direction of the arrow.

–

Replace the bobbin-housing top 2 in the shuttle.

–

Close bobbin-housing flap 1.