Operation Manual

2. Machine Elements and their Functions

2.1 Elements on the Machine Head

Element Function

1Screw – Regulating of the pressure foot pressure. The

Setting of the screw is to be fixed.

2Hand lever – Turning the edge cutter 10 on and off. The position

of the hand lever is variablly adjustable.

3Spooling device – See under Section 3.2 Spooling of the Bobbin

Thread.

4Control panel – See the motor manufacturer’s instructions.

5Oil reservoir – The oil level should not be allowed to drop below

"MIN". When necessary fill with ESSO SP-NK10 oil

to "MAX".

6Adjustment wheel – Setting the stitch length for reverse sewing (with

sub-classes -....41 via hand lever).

7Adjustment wheel – Setting the stitch length for forwardsewing (with

sub-classes -....41 via hand lever).

8Rest – For tilting the machine head to the back (not on

classes 273 and 274).

9Needle thread tension – Turn in direction + = higher needle thread tension

Turn in direction - = looser needle thread tension

10Edge cutter – Function see following page.

11Needle – System 134, 797 or Sy 1955-01

- Risk of Injury! -

Before replacing the needle it is essential to turn the main

switch off.

12Locking button – Lock the pressure foot in the raised position

13Hand lever – Setting the carrier roller up. It is swung out of the

work area. Sewing only with bottom feed

14Adjustment wheel – Transport length for the top feed roller

15Roller top feed – Function see following page