Operation Manual
Table Of Contents
- 271743-01-Deckblatt
- 271743-02-VoSi -D-
- 271743-03-Inhalt-D-1
- 271743-04-Inhalt-D-2
- 271743-05-VoSi -GB-
- 271743-06-Inhalt-GB-1
- 271743-07-Inhalt-GB-2
- 271743-08-VoSi -F-
- 271743-09-Inhalt-F-1
- 271743-10-Inhalt-F-2
- 271743-11-VoSi -E-
- 271743-12-Inhalt-E-1
- 271743-13-Inhalt-E-2
- 271743-14-VoSi -P-
- 271743-15-Inhalt-P-1
- 271743-16-Inhalt-P-2
- 271743-17-VoSi -I-
- 271743-18-Inhalt-I-1
- 271743-19-Inhalt-I-2
- 271743-Standbogen
8.2.8 Changing the Direction of Rotation with the OC-TOP Control Panel
Attention! The direction of rotation is correctly set at delivery .
–
Activate the special level (C) (see Chapter 8.2.6).
–
Change the parameter value <800>
–
Exit the special level (C) (see Chapter 8.2.6).
ATTENTION!
All needle positions must be set again after a change in the
direction of rotation. See Chapter 8.2.7.
68