Operation Manual

8.1.7 Changing Parameters in the Operator Level (A) in the DA40MS02 Controls

Prerequisite:

The mains switch is turned on, the pedal is in the base position, sewing is

not taking place, the display mode 4 is turned on (see Chapter 8.1.2)

Display

Display mode 4: Parameter and parameter value

Number Meaning Change via:

1-3 Parameter V+ or V- key

4 Programming level -

5-8 Parameter value V+ or V- key

Selecting parameters and changing the parameter value.

–

Press the C>> key, the number 1 in the display blinks, sewing is not longer

possible.

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased.

–

Press the C>> key, the numbers 2-3 in the display blink.

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased .

–

Repeat this procedure until the numbers 1-3 show the desired parameter value.

–

Press the C>> key, the numbers 5-8 in the display blink (parameter value).

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased .

–

Repeat this procedure until the numbers 5-8 show the desired parameter value.

–

Press the M+ or M- key, the blinking is ended, the change is thus saved, sewing is

possible again.