Operation Manual

8.1.6 Activating Sewing Functions
Prerequisite:
–
The mains switch is turned on.
–
The pedal is in the base position.
–
Sewing is not taking place.
–
The display mode 3 is turned on (see Chapter 8.1.2).
Display
In this display mode each position designation of the display is assigned to the symbol
which lies above the corresponding number.
Number
Symbol Sewing function Display Meaning
1 1 Beginning bartack 0 Beginning bartack off
1 Beginning bartack-single
2 Beginning bartack-double
2 2 Needle position at sewing stop 0 Needle position down
1 Needle position up
3 3 Sewing foot position at sewing stop 0 Sewing foot down
1 Sewing foot up
4 4 End bartack 0 End bartack off
1 End bartack-single
2 End bartack-double
5 5 Thread trimming 0 Without thread trimming
1 With thread trimming
6 6 Sewing foot position after 0 Sewing foot down
thread trimming 1 Sewing foot up
7 7 without function
8 8 without function
Changing the sewing functions
–
Press the C<< or C>> key, a number in the display blinks, sewing is not longer
possible.
–
Press the C<< or C>> key until the number which corresponds to the function to be
changed blinks, (e.g. number 4 for the end bartack)
–
Press the V+ key, the value of the blinking number is increased or
–
Press the V- key, the value of the blinking number is decreased.
–
Press the M+ or M- key, the blinking is ended, the change is thus saved, sewing is
possible again.
54