Operation Manual
Table Of Contents
- 271743-01-Deckblatt
- 271743-02-VoSi -D-
- 271743-03-Inhalt-D-1
- 271743-04-Inhalt-D-2
- 271743-05-VoSi -GB-
- 271743-06-Inhalt-GB-1
- 271743-07-Inhalt-GB-2
- 271743-08-VoSi -F-
- 271743-09-Inhalt-F-1
- 271743-10-Inhalt-F-2
- 271743-11-VoSi -E-
- 271743-12-Inhalt-E-1
- 271743-13-Inhalt-E-2
- 271743-14-VoSi -P-
- 271743-15-Inhalt-P-1
- 271743-16-Inhalt-P-2
- 271743-17-VoSi -I-
- 271743-18-Inhalt-I-1
- 271743-19-Inhalt-I-2
- 271743-Standbogen
8.1.4 Reducing the Maximum Speed in the DA40MS02 controls
In order to optimally set the maximum speed of the machine to the current individual
application, a reduction of the maximum speed is possible.
Prerequisites:
–
The mains switch is turned on.
–
The pedal is in base position.
–
Sewing is not taking place.
–
The display mode 2 is turned on (see Chapter 8.1.2).
Display:
Display mode 2: Maximum speed
Number Meaning Change via:
1 Character for the speed display -
3-6 Stitches-rpm V+ or V- key
8 Current programming level Chapter 8.1.7, 8.1.8, 8.1.9-
Reducing the maximum speed
–
Press the V- key, the maximum speed is lowered
–
Press the V+ key, the maximum speed is increased
Note!
The setting range lies between the parameter value <607> (maximum) and <606>
(minimum).
ATTENTION!
The maximum speed (value of the parameter 607) should
be set no higher than is listed in the parameter sheet (in
the accessories pack) for each class and subclass..
52