Operation Manual

8.1.3 Displaying and Changing the Number of Bartack Stitches at the DA40MS02

Controls

Prerequisites:

–

The mains switch is turned on.

–

The pedal is in base position.

–

Sewing is not taking place.

–

The display mode 1 is turned on (see Chapter 8.1.2).

Display:

Display mode 1: Number of bartack stitches

NumberMeaning Change via:

1 Number of forward stitches in the beginning bartack V+ or V- key

3 Number of reverse stitches in the beginning bartack V+ or V- key

5 Number of reverse stitches in the end bartack V+ or V- key

7 Number of forward stitches in the end bartack V+ or V- key

8 Current programming level Chapter 8.1.7,

8.1.8, 8.1.9

Programming:

–

Press the C>> or C<< key, a number blinks.

–

Press the V+ key, the value of the blinking number is increased.

–

Press the V- key, the value of the blinking number is decreased.

–

Press the C>> or C<< key until the number to be changed blinks.

–

Press the V+ or V- key until the desired value is set.

–

Press the M+ or M- key, the blinking is ended, the change thus saved.