Operation Manual
Table Of Contents
- 271743-01-Deckblatt
- 271743-02-VoSi -D-
- 271743-03-Inhalt-D-1
- 271743-04-Inhalt-D-2
- 271743-05-VoSi -GB-
- 271743-06-Inhalt-GB-1
- 271743-07-Inhalt-GB-2
- 271743-08-VoSi -F-
- 271743-09-Inhalt-F-1
- 271743-10-Inhalt-F-2
- 271743-11-VoSi -E-
- 271743-12-Inhalt-E-1
- 271743-13-Inhalt-E-2
- 271743-14-VoSi -P-
- 271743-15-Inhalt-P-1
- 271743-16-Inhalt-P-2
- 271743-17-VoSi -I-
- 271743-18-Inhalt-I-1
- 271743-19-Inhalt-I-2
- 271743-Standbogen
8.1.2 Display Functions
The display is only active when no OC-TOP control panel is connected.
The display has 8 different types of display:
After the turning-on of the mains switch the controls type is shown for approx. 1 sec.
Then the software status is shown briefly.
4 variable types of display are available for sewing and programming. The change-over
occurs via the M+ or M- key, when sewing is not taking place.
Display mode 1
: Number of bartack stitches
See Chapter 8.1.3
Display mode 2:
Maximum speed or current speed
See Chapter 8.1.4 and 8.1.5
Display mode 3
: Sewing functions
See Chapter 8.1.6
Display mode 4
: Parameter and parameter value
See Chapter 8.1.7
Two further display types are available for the hardware test and the master reset:
Hardware test display
See Operating Instructions Mini Stop Type DA40MS02 (in the accessories pack)
Master reset display
See Chapter 8.1.13
50