Operation Manual

7 Base position of needle = down Left arrow above the key on
Base position of needle = up Right arrow above the key on
8 Remaining thread monitor on xxxx - - I I - -
The manner of operation of the remaining thread
monitor can be changed with parameter 195.
(See Efka parameter list)
9 Function key
The function of the key can be changed with
parameter F-008 (see Parameter list
Chapter 7.1.3)
1 = Softstart ON/OFF SSt ON*/OFF < -- > SSc xxx
2 = Fancy-stitch bartack ON/OFF SrS ON*/OFF
3 = Stroke adjustment hPr ON*/OFF
Manner of operation of the knee switch
or key:
"locking" = ON / "provisional" = OFF
4 = Needle cooling ON/OFF nh ON*/OFF
* at ON the left arrow above
the key is turned on.
0 Teach in or Number of the program
sewing of the stored sewing program. Number of the seam run
See Programming Instructions in the Operating Number of stitches in the seam run
Instructions
EFKA DA220C 5300 Number of stitches after light barrier
detection
A Bartack suppression or bartack call-up no display
If beginning or end bartack are turned on,
pressing the key will turn off the next
bartack.
If beginning or end bartack are turned off,
pressing the key will turn on the next
bartack.
B Needle high/low no display
or shift function in the programming mode.
By pressing the key, a
needle movement is conducted which can be
programmed with parameter 140. See
Instructions manual, table chapter 6.16
the key has a different function. See
Chapter 7.3.8.
P Programming mode on/off Parameter number/Standard display
See Chapter 7.3.4 and 7.3.7
E Change-over from the parameter number to Parameter number/Parameter value
the value of the parameter.
Confirmation of the parameter value and
advance to the next parameter.
See Chapter 7.3.4 and 7.3.7
+ Increase of the value shown The displayed value is increased
in the programming mode
- Decrease of the value shown The displayed value is decreased
in the programming mode
GB
41