Operation Manual
Table Of Contents
- 271743-01-Deckblatt
- 271743-02-VoSi -D-
- 271743-03-Inhalt-D-1
- 271743-04-Inhalt-D-2
- 271743-05-VoSi -GB-
- 271743-06-Inhalt-GB-1
- 271743-07-Inhalt-GB-2
- 271743-08-VoSi -F-
- 271743-09-Inhalt-F-1
- 271743-10-Inhalt-F-2
- 271743-11-VoSi -E-
- 271743-12-Inhalt-E-1
- 271743-13-Inhalt-E-2
- 271743-14-VoSi -P-
- 271743-15-Inhalt-P-1
- 271743-16-Inhalt-P-2
- 271743-17-VoSi -I-
- 271743-18-Inhalt-I-1
- 271743-19-Inhalt-I-2
- 271743-Standbogen
B Needle high/low no display
or shift function in the programming mode.
By pressing the key, a needle
movement is conducted which can be
programmed with parameter 140. See
Instructions manual, table chapter 6.16.
In the programming mode the
key has a different function. See
Chapter 7.2.6.
P Programming mode on/off Parameter number/Standard display
See Chapter 7.2.4 and 7.2.6
E Change-over from the parameter number to the Parameter number/Parameter value
value of the parameter.
Confirmation of the parameter value and
advance to the next parameter.
See Chapter 7.2.4 and 7.2.6
+ Increase of the value shown The displayed value is increased
in the programming mode
- Decrease of the value shown The displayed value is decreased
in the programming mode
7.2.3 Meanings of the Symbols in the V810 Control Panel
Symbol Function Display
C Automatic speed activated Symbol on
Only with automatically conducted
seam runs.
D Light barrier turned on Symbol on
E Sewing drive turned on Symbol on
F Speed limitation activated Symbol on
G Bobbin thread monitor turned on Symbol blinks
when the bobbin nears empty.
GB
35