Operation Manual

LED Function
LED1 lit Indicator for single beginning bartack
LED2 lit Indicator for double beginning bartack
LED1 and LED2 off Beginning bartack off
LED3 lit Indicator for single end bartack
LED4 lit Indicator for double end bartack
LED3 and LED4 off End bartack off
LED5 lit Indicator for automatic sewing foot lift by stop in the seam
LED6 lit Indicator for automatic sewing foot lift after the
thread trimming.
LED7 lit Indicator for base position of the needle = down
LED8 lit Indicator for base position of the needle = up
Display 3-digit indicator for speeds, parameters and code numbers
7.1.1 Changing Parameter Values at the Operator Level in the DA220C controls
The parameter values at the operator level (see Parameter list Chapter 7.1.3) can be
changed without entering a code number.
7.1.1.1 Sequentially Calling up and Changing Parameters at the Operator Level in
the DA220C controls
–
Turn the main switch on.
–
The display shows the value for the maximum speed e.g. "
480
" = Display for
4800/min.
–
Press the "
P
" key, the first parameter "
0.0.0.
" is shown.
–
Press the "
E
" key, the corresponding parameter value e.g. "
002
" is shown.
–
Press the "
+
" key, the parameter value is increased.
–
Press the "
-
" key, the parameter value is decreased.
–
Press the "
E
" key, the next parameter "
0.0.1.
" is shown.
–
Press the "
E
" key, the value of the parameter "
0.0.1.
" e.g. "
004
" is shown. etc.
(In this manner all parameters at the operator level can be called up sequentially
and changed. After the last parameter the programming at the operator level must
be exited) or one can exit the programming at the operator level at any time.
–
Press the "
P
" key, the same parameter "0.0.1." is shown.
–
Press the "
P
" key, the programming at the operator level is exited. The display
shows the value for the maximum speed e.g. "
480
" = Display for 4800/min.
–
After the programming at the operator level has been exited the altered values are
saved in memory.
GB
25