Operation Manual

Set-up
Operating manual 171/173 Version 01.0 - 01/2016 67
6.13 Electrical connection
6.13.1 Checking the mains voltage
Important: The voltage on the type plate of the sewing drive must
correspond to the mains voltage.
1. Check the mains voltage before connecting the machine.
6.13.2 Connecting the controller
Connecting the controller consists of the following work:
• Insert the plugs of all connecting cables in the sockets
on the back of the controller.
• Connect the controller to the power supply using the
powe
r cable.
To do this, read the  ope
rating manual for the DAC eco
or DAC classic controller. The operating manual is provided
in the controller accessory pack. You can also find the
o
perating manual for the controller in the download area
at www.duerkopp-adler.com.
Danger to life due to electric shock.
The machine may only be connected by trained
electrical specialists.
Disconnect the power plug before carrying
out work on the electrical equipment.
Make sure the power plug cannot be unintentionally
reinserted.
The voltage on the type plate of the sewing drive
must correspond to the mains voltage.
DANGER
Danger to life due to electric shock.
Disconnect the power plug before connecting
the controller.
Make sure the power plug cannot be unintentionally
reinserted.
DANGER