Operation Manual

3.3 Adjusting the contour guide
Caution: Risk of injury!
Switch the main switch off.
Adjust the contour guide only with the sewing unit switched off.
Standard
The contour guide 1 should move forward as far as to ensure that both
material plies 2 are always guided safely when sewing the contour.
Correction of the swivelling width
–
Loosen the clamping lever 3.
–
Shift the contour guide 1 correspondingly.
–
Tighten the clamping lever 3.
Correction of the stamp position
–
Loosen nut 6.
–
Turn the stamp 1 correspondingly.
–
Tighten nut 6.
20
2 1 1 3