Operation Manual

2-14
8. Press the Special key to leave the setup page and store the changes.
9. Repeat this procedure for all inputs and outputs which you want to modify.
3.7.2 Settings for this machine
The inputs and outputs at this machine should be programmed as follows:
Inputs
Mouse backward
M1
Fn
F11 ON
Stacker impulse
M2
Fn F7 ON
Pulling device up
M3 Fn F8 TOG
Mouse backward
M7 Fn F11 ON
Outputs
Table blowing
F2
100 100
Contour guiding up and blowing in the contour guiding
F3 STEP
530
Contour guiding backward / forward
F4
STEP
045
Kett-up
F5
0 450
Smooth-out device up/down
F6
STEP
800 100
Stacker impulse
F7
075
Pulling device up/down
F8 STEP
050