Operation Manual

2-12

All values must be set like shown in the drawing.

JS jog speed: this function is not used at this machine;

KJ speed factor in POS mode: speed for the smooth-out distance;

KP speed factor in puller mode (1 ... 15): speed factor for the synchronous

operation (1 ... 7 = half step mode; 8 ... 15 = full step mode);

KA acceleration curve of the step motor;

IL holding voltage in home position (1 ... 15): this should reduced to a

minimum to avoid over heating;

IH working voltage (1 ... 15): here you have to consider the

manufacturer’s information; if the working voltage is set too high, the

motors will be destroyed.

ATTENTION

Damage to the motors due to inadequate settings! Before you modify one of

the values shown here (especially value IH), you should contact the Beisler

service staff.

3.6 Setup page -10

M3M2

F12

F11

F10

F8F7

SETUP

-10

All inputs (F1 ... F12) and outputs (M1 ... M8) are displayed on this page. For

diabled inputs/outputs, the respective icon is crossed out.

At this machine, the output F1, and the inputs M3 ... M6 and M8 must be

disabled. Position the cursor on the icon of an input/output and press the

Plus/Minus key to alter the setting.

The outputs are valves and occupied as follows:

Valve description Output connector

F1 Y1 Lift sewing foot pin 1

F2 Y2 Table blowing pin 3

F2 Y13 Waste evacuation (option with stitch type 515) pin 3

F2 Y16 Tension release for needle thread (option stitch type 515) pin 3

F3 Y3 Contour guiding up and blowing in the contour guiding pin 5

F4 Y4 Contour guiding forward/backward pin 7

F5 Y5 Kett-up pin 9

F6 Y6 Smooth-out device up/down pin 11

F7 Y7 Stacker impulse pin 13

F8 Y8 Transportation unit up/down pin 15

F9 Y9 Top feed adjustment pin 17

F10 Y10 Bottom feed adjustment pin 18

F11 Y11 Mouse backward pin 14

F12 Y14 Drive contour guiding laterally (see below) pin 14

Y15 Stacker up/down (option) pin 12 +24 V pin 19 -24 V