Operation Manual

6.4.2 Altering global parameters
Parameter 29: Needle feed
Maximum run
Input: 0 …120
Parameter 38: Start delay light barrier
Input: 0 …2000
Parameter 39: Differential feed
Maximum run
Input: 0 …120
Parameter 40: Basic value needle feed
Input: 0 …120
Parameter 41: Basic value needle feed on / off
Input: 0 / 1
Parameter 42: Basic value differential bottom feed
Input: 0 …120
Parameter 43: Basic value differential bottom feed on/ off
Input: 0 / 1
Parameter 45: Number of stitches until the table blowing is
switched on
Input: 0 …400
Parameter 46: Duration of the stacker impulse
Input: 0 ...2000
Parameter 47: Time of the stacker movement
Input: 0 …2000
Parameter 48: Speed limitation
Input: max. 6500
Parameter 49: Speed during the warp separation
Input: 500...5000
Parameter 50: Number of stitches until the thread tension is opened
(seam end)
Input: 0....50
Parameter 56: Seam programming on/ off
On = 1 Determine the seam sequences in the
current program
Off = 0 Create the next free program with seams
Input: 0 / 1
Parameter 58: Display of the software version
Parameter 59: Number of stitches how long the seam chain is
sucked (seam beginning)
Input: 0 …50
Parameter 65: Thread tension lift
Input: 0 …50
Parameter 79: Soft start after “Stop in the seam”
Input: 0 …500
Parameter 80: Reset daily piece counter
28