Operation Manual

F2 = C ard -> C urrentseam (data transferfrom the m em ory card to the control)
Data secured on the m em ory card can optionallybetransfe rre d tothe
contro l a s individualprogram oras com plete data poolofallprogram s.
Note
Ifthe com plete data poolofallprogram s istransfe rre d tothe contro l,
alldata are overw ritten,even seam s w hich had been altered inthe
m eantime.
Therefore alterations ofseam s shouldalwaysbe im m ediatelystored
as individualdataprotection on thememorycard.
–
Push th e m e m o ry c a rd intothe slotofthe operating term inal.
–
Press key “P”.
The program m ing m enus are called up.
–
Press key “F2”.
The functionMEMORYCARD iscalled up.
Transfer the selected program to the control
–
Press key “F2”.
Transferthe selected program indicated on the display.
The function CARD -> CURRENT SEAM iscalled up.
or
Transfer allprogram s to the control
–
Press key “F4”.
Transferthe com plete data poolofallprogram s.
The function CARD -> M ACHINE MEMORYiscalled up.
–
Press key “E N T”.
The checkback is confirm ed.
The display indicates*O K PLEASE W AIT!*Thisisahintthatthe
datatransferis bein g c a rried out.
F5 = M em ory Card Form at
Ifadditionalm em ory cards (optionallyavailable)are used fordata
back-up,the storage m edium has tobeform atted before being used
forthe firs t time.
–
Push th e m e m o ry c a rd intothe slotofthe operating term inal.
–
Press key “P”.
The program m ing m enus are called up.
–
Press key “F2”.
The functionMEMORYCARD iscalled up.
–
Press key “F5”.
The function MEM ORY CARD FORM AT iscalled up.
The display indicates the checkback *AR E Y O U SU R E ?*
–
Press key “E N T”.
The checkback is confirm ed.
The display indicates*O K PLEASE W AIT!*. T h isisahintthatthe
form atting is bein g c a rried out.
52