Operation Manual

F3 = Copying the seam num ber (program num ber)
ATTENTION!
The currentprogram is o v e rw ritten.
–
Press key “P”.
The program m ing leveliscalled up.
–
Press key “F1”.
The function INIT PARAM ETER iscalled up.
–
Press key “F3”.
The function CO PYING OF SEAM NUM BER iscalled up.
–
Enterthe num berofthe program tobecopied viathe num eric pad.
–
Press key “E N T”.
C onfirm the copying.
The display indicates*O K PLEASE W AIT!*. T h isisahintthatthe
copying is bein g c a rried out.
Finallythe display ofthe program show s the program num berw ith
the seam s.
F4 = Deleting a seam program
A program consists ofseveralseam s.
The contentsofthese seam s,the seam param eters,can be deleted
com pletely.
The currentprogram cannotbe deleted.
–
Press key “P”.
The program m ing leveliscalled up.
–
Press key “F1”.
The function INIT PARAM ETER iscalled up.
–
Press key “F4”.
The function DELETE SEAM iscalled up.
–
Enterthe num berofthe seam tobedeleted w ith one ofthe keys
“1 ” to“9”.
–
Press key “P”.
Startthe deleting procedure.
The display indicates a checkback
“ARE YOU SURE ?*
–
Press key “E N T”.
The new setting isstored and you return tothe selection m enu.
The display indicates*O K PLEASE W AIT!*. T h isisahintthatthe
deleting procedure is bein g c a rried out.
50