Operation Manual

6.11 Program m ing m enus

6.11.1 G eneralnotes

The program m ing m enus allow the generation ofprogram s and the

corresponding seam s.

Inprincipalitis possibleto generate a com plete new program .An

easierw ay is:

l to copy a program provided by the m anufacturertoafre e s torage

location inthe m em ory and to adaptittothe conditions ofyour

production.

l to copy an already m odified program toafre e s torage location inthe

memoryandtofurtheradaptit.

In orderto generate a new program the follow ing steps are required:

1) A llocateafre e s torage location

2) A dd seam s orcopy existing seam s

to a program

3) C onfigurate seam s (adaptthem tothe production)

Scrolling dow n the program m ing levels

W hen the program m ing m enus are called up,the m enu dealtw ithlast

isalwaysindicated.

The num berpreceding the functions show s w hich program m ing level

has been called up.

In ordertocallupacertainfunction you have to scrolldow n the

program m ing m enus and service m enus.

Calling up a program m ing m enu

–

Press key “P”.

Scrolling dow n a program m ing m enu

–

Press key “ï“.

6.11.2Allocating a fre e s torage location

The storage locations M 01 -M 10 have been provided w ith program s by

the m anufacturer.The storage locations M 11 -M 20 are free.

–

Press key “M ”.

–

Enterthe two-digitnum berviathe num eric pad.

6.11.3F1=INIT Param eter

Functions inthe m enu InitP aram eter:

l F1 = EPRO M globalparam eter

F2 = EPRO M seam param eter

F3 = copy seam num ber

F4 = delete seam