Operation Manual

5.6 Fusing station (optional)

5.6.1Inserting adhesive tape

–

Rem ove the rightsupporting disk by pulling the handle1strongly.

–

Inserta new rollofadhesive tape 2.

The fullrollm ustrotate counte r-c lockw ise w hen unw inding.

–

Push the rightsupporting disk w ith handle1onthe shaftagain until

itcatches.

–

Guide the adhesive tape through guide 3.

–

O pen flap 4 upw ards.

–

Separatethe adhesive tape2fro m th e c a rrierm aterial5.

–

Guide the adhesive tape 2 underthe flap 4 and draw itunderthe

clam p 7.

–

Guide th e c a rrierm aterial5 dow nw ards behind the transportroller6.

–

Close flap 4.

5.6.2Switching the fusing station on and off

–

The yellow signallamp1“Power”lightsupafterthe m ainswitch

has been sw itched on.

–

Press the toggleswitch2in position “O N ”.

Note

As long as the signallam p 3 “H eat”flashes,the low erstam p is being

heated up and has notyetreached the necessary tem perature.

76 542

432 1