Operation Manual

Set-up
Operating manual 100-69 version 00.0 - 05/2013
62
6.2.3 Setting the working height
The working height is adjustable between 797 and 1138 mm (measured
to the upper edge of the table plate).
The sewing unit is set to the lowest working height of 797 mm at delivery.
Fig. 47: Setting the working height
Set the height of the sewing unit by pulling equally the tubular feet of the
frame.
1. Loosen screws (1) (4x).
2. Level out the table top at the desired working height.
To avoid a jamming, pull out resp. push in the tubular feet equally on
both sides.
3. Tighten screws (1).
Be careful when loosening the attachment screws.
The sewing unit may keel over when the tubular
feet of the frame are pulled out.
CAUTION
཰
(1) - Screws
཰