Operation Manual

Operation

Operating manual 100-69 version 00.0 - 05/2013

Fig. 38: Throw-over stacker swung-out

Function sequence

• During the sewing cycle the material runs into the opening between

the stacked goods stand (4) and the clamping pipe (3).

• After the incision of the corners and the lifting of the feed clamps, the

stacking process is triggered by a control pulse. The clamping

pipe (3) and the smoother (1) swivel against the stacked goods

stand (4).

The work piece is clamped.

• A pneumatic cylinder retains the clamping pipe (3) at the stacked

goods stand (4).

• The clamping pipe (2) opens.

For this it swivels away from the stacked goods stand (4).

• The smoother (1) lifts and smoothes out the workpiece above

stacked goods stand (4) and holder (5) and then moves to its initial

position.

• The clamping pipe (2) closes.

For this it swivels back against the stacked goods stand (4) and

clamps the stacked workpiece.

• The clamping pipe (3) and the smoother (1) swivel back together to

their basic position. The clamping pipe (2) is thereby retained at the

stacked goods stand (4).

཰

ཱུ

ུ

ཱི

ི

ཱ

(1) - Smoother

(2) - Clamping pipe

(3) - Clamping pipe

(4) - Stacked goods stand

(5) - Holder

(6) - Foot pedal