Operation Manual

Operation
Operating manual 100-69 version 00.0 - 05/2013
44
Fig. 31: Tape feed in detail (depicted without tape roll)
Fig. 32: Setting
1. Loosen screw (1) and pull off the setting ring (2) from the shaft.
2. Remove the empty tape roll including the adapter (3).
3. Insert the adapter (3) into a new tape roll on both sides (right and left).
4. The full tape roll has turn while unwinding.
5. Push the setting ring (2) back onto the shaft and tighten screw (1) again.
6. Guide the reinforcement strip consecutively through guide (7) and (5).
7. Swivel the fabric sliding sheet (8) aside.
8. Press the damper slide (10) to the rear and lift off the cover (9).
9. The reinforcement strip is cut off and moved to the initial position.
10.Swivel the fabric sliding sheet (8) back again.
11.-Press the icon.
The reinforcement strip is cut and pushed to the initial position.
(1) - Screw
(2) - Setting ring
(3) - Adapter (inside)
(4) - Wire bow
ཱི
཰
ཱི
ཷླྀཹ
(8) - Fabric sliding sheet
(9) - Cover
(10) - Damper slide