Operation Manual

Parallelism of the carriers 1 to the fabric sliding sheet

–

Loosen screw 3.

–

Turn holder 2 in such a way that both carriers 1 have the same

distance to the fabric sliding sheet.

Height of the carriers 1 as to the fabric sliding sheet

–

Loosen counternut 5.

–

Turn the piston rod in such a way that there is a distance of approx.

0.5 mm between the lowered carriers and the fabric sliding sheet.

Adapting the carriers 1 to the seam distance

The carriers are adapted to the seam distance by bending.

–

Align the carriers cautiously by lateral bending.

Front adjustment of the carriers

The carriers are positioned correctly if there is a distance of approx. 2

mm between the rotary disc 6 of the scissors and the guide rail 7 in the

front end position of rail 7.

–

Push the guide rail 7 right to the front.

–

Loosen screws 8.

–

Adjust the guide rail in such a way that there is a distance of

approx. 2 mm between the rotary disc 6 of the scissors and the

guide rail 7.

–

Tighten screws 8.

Carriers of the guide rail

The buffers 10 of the carriers have to be extended by the cylinders 9

so far that the guide rail is transported without slippage.

The distance between the buffers 10 of the carriers should be narrower

than the thickness of the guide rail.

–

Unscrew cylinder 9.

–

Adjust the piston rods of the cylinders correspondingly.

–

Screw cylinder 9 on again.