Operation Manual

2.1.1 Position of the limit switch in the slotted hole
Checking
–
Unscrew the screws 8 and take off the covering cap 9.
–
Check the position of the limit switch 1 in the slotted hole 2.
Correction
–
Loosen the upper counternut at the limit switch 1.
–
Push the limit switch to the very rear of the slotted hole.
–
Tighten the upper counternut again.
Attention: Risk of breakage !
After operations on the limit switch always check the distance to the
switching screw 4.
2.1.2 Distance between switching screw and limit switch
Checking
–
Push the transport carriage 5 to the rear until the switching screw 4
is located under the limit switch 1.
–
Check the distance of 1 mm between limit switch 1 and switching
screw 4.
Correction
–
Loosen the counternut 3 at the switching screw 4.
–
Adjust the height of screw 4.
Distance between switching screw and limit switch=1mm.
–
Tighten the counternut 3.
2.1.3 Stop guide for the transport carriage
Checking
–
Push the transport carriage 5 to the rear until the surface of the
switching screw 4 is located centrically above the limit switch 1.
–
Check whether in this transport carriage position the distance
between the stop guide 6 and the transport carriage amounts to 2
mm.
Correction
–
Push the transport carriage to the rear until the surface of the
switching screw 4 is located centrically above the limit switch 1.
–
Loosen the counternut 7.
–
Approach the stop guide 6 to the transport carriage by 2 mm.
–
Tighten the counternut 7.
3
7