Operation Manual

6.6.4.2 Reading data from the USB stick
Machine parameters, program sequences and seam programs can
individually be read from the USB stick.
ATTENTION!
During the data transfer to the control the sewing unit must not be
switched off.
When transferring programs from one sewing unit to another only
transfer the program sequences and seam programs.
–
Plug the USB stick in the plug-in position at the side of the control
unit when the main screen is displayed.
The following screen appears:
–
Tap the data to be saved by the USB stick.
A checkmark appears in the checkboxes.
–
Tap the “OK key.
The loading process starts.
A light-emitting diode flashes at the USB stick.
When the saving process is finished, the right screen appears.
–
Unplug the USB stick.
–
Press the ESC key until the main screen is displayed.
52