Operation Manual

13 Cutting duration of zipper scissors
Influences the zipper scissors in such a way that it cuts the zipper
completely before moving to the end positiont.
Input: min = 0,0, max = 0,5
Factory setting: 0,5 s
14 Moving to the cutting position
Percentage of the speed of the main clamp when moving to the corner
knives.
Input: min = 10, max = 99
Factory setting: 25%
15 Distance of corner knives
Distance between the corner knives
Adjustment of the front and rear corner knives in the reference
position.
Input: standard corner knives 50 mm
bias corner knives 56 mm
Factory setting according to equipment
16 Corner knife cutting
Cutting duration of the corner knives.
Input: min = 0,0, max = 1,0
Factory setting: 0,3 s
17 Main clamp open
Opening of the main clamp after corner trimming.
If a too short time is set, the workpiece may slide out of the machine
before being taken over by the stacker.
Input: min = 0.0, max = 1.0
Factory setting according to equipment
18 Taking over of workpieces
When returning the workpieces by a non-fixed clamp (processing of
inside pockets) the main clamp opens after corner trimming and the
ejector roller transports the workpiece out of the clamp sideways.
Afterwards the clamp is switched via this parameter so that the
workpiece is quickly scanned and transported to the feeding position
by the main clamp.
Input: min = 0,0, max = 1,0
Factory setting: 0,5 s
19 Until the rotation of the ejector roller
Time for the start of the ejector roller rotation.
Input: min = 0,0, max = 1,0
Factory setting: 0,1 s
20 Until ejector roller up
Holding the workpiece after ejecting until the stacker has taken it over
safely.
Input: min = 0,0, max = 3,0
Factory setting: 0,5 s
4
25