Installation Sheet

Safety instructions
Cut and crush injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations and
any country-specific standards at all times.
> Equalise pressure differences between cold
and hot water connections.
> Observe the manufacturer’s instructions for
installation with continuous flow heaters.
These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a qualified
plumber.
Explanation of the key words
CAUTION
Indicates a hazardous
situation which, if not
avoided, could result in minor
or moderate injury.
NOTICE
Addresses practices not
related to physical injury.
Technical data
Operating pressure max. 72.5 PSI
Recommended 43.5 PSI
Test pressure 72.5 PSI
1 MPa = 10 bar = 145 PSI
Hot water temperature max. 140 °F
This unit meets or exceeds the
following:
• ASME A112.18.1
• CSA B125.1
• ADA Compliant
4 MAL_57159/17.06.1
en