Leben im Bad Living bathrooms Architec Mounting instructions Alcove Installation
Architec # 700353 # 700354 # 700355 # 700356 2 Architec_US_.14.11.
4 Installation 6 Waste and Overflow installation 8 10 Cleaning and Care Architec_US_.14.11.
en Important information Regarding the mounting instructions These mounting instructions comes as part of the Duravit bathtub and should be read carefully prior to installation. Explanation of key words and symbols NOTE! Products are in compliance with following codes: Uniform Plumbing Code National Plumbing Code of Canada International Plumbing Code Products are in Compliance with the following standards CSA B45.
# 700353 # 700354 # 700355 # 700355 # 791224 Architec_US_.14.11.
1 2 3 1 Inspect tub for any potential damage that may have occured during transport. 4 13 5 DANGER! Fatal injury by electric shock. Make sure that there are no electrical wires or heating running under the floor, which could be affected by the installation of tub. 6 Place cardboard or blanket on the floor and turn tub over. Architec_US_.14.11.18 Connect tub waste and overflow. 6 x6 Affix 6 flange clips to the wall frame for side support of the tub.
Once tub is set, finish wall and tile and apply silicone as needed. Architec_US_.14.11.
Waste & Overflow Installation 1 2 3 1 2 A 2 2 1 1 A B 2-1/2" B (62.75) Measure vertical distance of overflow to drain and cut pipe length. Measure horizontal distance of drain center to overflow and cut drain pipe to match length. Attach rubber gasket and install the overflow against interior of wall. 4 5 6 2 “Click” « Clic » “Clic” 1 3 4 5 6 Using provide tool, attach to chrome trim piece and connect to overflow. Turn tool Clockwise to tighten into place. 8 Architec_US_.14.11.
7 8 6 “Click” « Clic » “Clic” 90° 9 2 1 5 1 2 3 4 3 Once set, turn sleeve 90 degrees to secure push button to overflow and then remove yellow sleeve. Connect drain and overflow using gasket and adaptor. Using provided gaskets, attach the drain to the tub and insert get screw to drain. 10 11 12 Connect cable and ensure it is tight. It cannot have slack. Insert drain cover to drain and press overflow button to actuate a sync.
Cleaning and Care ACRYLIC Surface cleaning Clean the surface with a soft cloth and soapy water. Do not use abrasive cleaning liquids. For removing stains we advise using the Duravit care kit for acrylic surfaces (see picture I). More resistant stains can also be removed with warm water and a mild, liquid detergent or soap sud. Lime stain Lime stains can be taken off with brandy vinegar and water. After treatment rinse with clear water.
Architec_US_.14.11.
Duravit USA, Inc. 2205 Northmont Parkway Suite 200 Duluth, GA 30096 Toll Free 1-888-DURAVIT Phone 1-770 931-3575 Fax 1-770 931-8454 info@us.duravit.com www.duravit.us Architec.14.9.17 We reserve the right to make technical improvements and enhance the appearance of the products shown. Duravit NYC 105 Madison Avenue New York, NY 10016 Toll Free 1-888- DURAVIT Phone 1-770-931-3575 Fax 1-770-931-8454 info@us.duravit.com nyc.duravit.
