Installation

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
19
Figure 43 - Flanged adaptor (FHA illustrated)
Flanged adaptor
Half ring
Beam clamp
Appliance
flanged
outlet
Figure 42 - ANSI flange adaptor (FA illustrated)
Flange adaptor
Gasket
(by other)
Bolts and nuts
(by other)
ANSI 125 or 150
pipe flange
Appliance outlet
Figure 44 - DIS / DCT, DCT / DIS adaptor
DIS / DAS female connection
DCT male connection
DCT female connection
DIS / DAS male connection
TERMINATIONS
Note: Installation of model DIS / DAS chimney can be completed
without any terminations if not necessary.
Rain Cap (RC)
1. Installed at the top of the chimney, it provides the greatest degree of
rain protection.
2. Three models of rain cap are available dependently of the diameter,
see Figure 45.
3. Do not use with turbine or engine exhaust.
4. Installation is done the same manner as a standard length except for
model 3. For this model, there are 3 additional steel straps to be screwed
to the chimney outer casing to ensure resistance to high wind.
Finishing Cone (FC)
1. Used to create a better draft when installed at the top of the chimney,
see Figure 46.
2. Requires a drain at the bottom of the stack to collect rain entering
the chimney.
3. Installation is done as a standard length.
Flip Top (FT) (DIS only)
1. Used in diesel or turbine exhaust, it prevents moisture and debris
from entering the system. See Figure 47.
2. Flip top opens with internal pressure and closes when no pressure.
3. Install as a standard length.
Miter Cut (MC)
1. Used in diesel or turbine exhaust as an horizontal termination. See
Figure 48.
2. Installation is done as a standard length.
Figure 45 - Rain Cap models
5” to 10” Ø
20” to 36” Ø
12” to 18” Ø
Optional bird screen
5” to 18” Ø