Instruction

7
chimney height supported by the various
components and must be followed throughout
this instruction, this data applies to both styles.
Items in Table 2 noted N/A are not load bearing
components.
Figure 7
BAND-BRACKET CONNECTIONS
For Universal components, use the carriage
bolt through the band and through the leg.
Use (1) at washer, (1) locking washer, and (1)
nut per side to secure to carriage bolt (Fig.5).
Ensure carriage bolts are directly across from
each other.
WALL SUPPORTS/RE-SUPPORTS
Wall Supports, Re-Supports, and Tee Supports
can be used interchangeably (Fig.6) to support
the chimney on vertical runs.
STEP-BY-STEP DIRECTIONS
There are ve general types of DuraTech
Chimney installations- Review the step-by-step
directions before beginning your installation.
1.Ceiling-supported (p.7)
2.Roof-supported (p.14)
3.Tee-supported-through-the-wall (p.16)
4.Masonry Fireplace (p.20)
5.Zero-Clearance Fireplace (p.21)
METHOD 1: CEILING SUPPORTED
1. Place Appliance: Position the appliance
according to the manufacturer’s instructions.
The ue outlet collar should be placed
between the rafters or joists above, if possible.
2. Frame Support Opening: Drop a plumb bob
to the center of the appliance’s ue outlet and
ROUND MUST EXTEND
MIN 3” BELOW
FINISHED CEILING
Figure 5
CARRIAGE BOLT
FLAT WASHER
LOCKING WASHER
NUT
UNIVERSAL
SUPPORT BAND
Figure 6
MOUNTING
HARDWARE- #8
WOOD SCREWS
WITH WASHER
EXTENDED
WALL SUPPORT
JOISTS & FRAMING
PER TABLE 1
SQUARE SUPPORT
BOX
ROUND SUPPORT
BOX- SQ TRIM
SQUARE MUST
EXTEND MIN 2” BELOW
FINISHED CEILING
(MIN POINT IF ANGLED)