Instruction

18
to insure that Tee is centered through Wall
Thimble (Fig.25). Use the 1/2” sheet metal
screws provided to insure a tight connection
between support band and chimney section.
Connect support band to support base using
the 1/2” sheet metal screws provided (Fig.25).
Twist lock Tee Cap into bottom of Chimney
Cleanout section.
6. Install Branch onto Tee: From inside
the house, attach the Chimney Branch up
to 24” chimney section, depending on wall
thickness, positioned horizontally used to pass
through the wall) to the Tee by twist locking
it clockwise. Important: The Chimney section
Figure 25
USE 1/2”
SHEET METAL
SCREWS TO
SECURE BAND
TO SUPPORT
BASE
USE (4) 1/2”
SHEET METAL
SCREWS TO
SECURE BAND
AROUND
CHIMNEY
CLEANOUT CAP
INSTALLATION WITH TEE
BELOW TEE SUPPORT
(SHOWN WITH LEG
BRACKETS MOUNTED
ABOVE SUPPORT
PLATE)
TEE SUPPORT MAY BE
INSTALLED WITH LEG GUSSETS
ABOVE OR BELOW SUPPORT
PLATE AS SHOWN
8-PENNY NAILS OR #8, 2 1/2”
WOOD SCREWS, 4 PER SIDE
ADJUSTABLE TEE
SUPPORT
ADJUSTABLE WALL STRAP,
8-PENNY NAILS OR #8,
2 1/2” WOOD SCREWS,
2 PER SIDE
Figure 24
FINISHING COLLAR
TEE CAP
CHIMNEY SECTION
CHIMNEY TEE
USE 8 PENNY NAILS OR #8, 2 1/2” WOOD
SCREWS. USE 4 FOR EACH SUPPORT LEG.
TEE BRANCH (MUST
PENETRATE A MINIMUM
OF 6 INCHES INTO ROOM)
WALL THIMBLE
ASSEMBLY
TEE SUPPORT IS ADJUSTABLE FOR
DISTANCE FROM CHIMNEY TO WALL.