Installation Instructions
12
The Vinyl Siding Standoff prevents
excessive heat from potentially warping
or melting the vinyl siding material.
Vinyl Siding Standoffs are not used with
Snorkels. The Vinyl Siding Standoff is
available in either a 1-piece version or a
4-piece version.
Cut a square opening in
the vinyl siding centered around the
framed opening, in accordance with the
dimensions provided in Table 1, page 8.
Mount the Vinyl Siding Standoff to the
wall using the screws provided.
Seal around the perimeter of the Vinyl
Siding Standoff using non-hardening
waterproof sealant to help ensure a
weather tight seal.
Secure the Horizontal Termination Cap
to the Vinyl Siding Standoff using the (4)
long screws provided with the cap.
The Vinyl Siding Standoff
should be assembled and installed
on the wall between the Horizontal
Cap and the building exterior. Cut
a square opening in the vinyl siding
centered around the framed opening,
in accordance with the dimensions
provided in Table 1, page 8.
The 4 pieces of the Vinyl Siding
Standoff (or Counter Flashing) must
be assembled in specic order to help
ensure a weather tight t.
Loosely assemble the four parts,
in order, around the opening in the
vinyl siding. Place the rst of 4 pieces
along the upper edge of the opening in
the vinyl siding. Progressing counter-
CUT EXTERIOR
OF WALL AS
REQUIRED IN
ASSEMBLE VINYL
STANDOFF/COUNTER
SPECIFIC ORDER
TABLE 1
FLASHING IN
VINYL SIDING,
STUCCO OR OTHER
SIDING MATERIAL
1
2
3
4
HOT
HOT
HOT
4 PC. KIT
ASSEMBLED IN
SEQUENCIAL
ORDER
FASTEN THE
4 CORNERS
THROUGH
THE HOLES
PROVIDED
FASTEN TERMINATION
TO ASSEMBLY
THROUGH THE
HOLES PROVIDED
SQUARE
ROUND
CAP
SCONCE
CAP
CAP
1st
2nd
3rd
4th
HOT
PLUMB AND LEVEL
ENSURE ASSEMBLY IS
GAPS
& SCREWS
SEAL ALL
CONNECT TO WALL
AS REQUIRED