Installation
10
installation instructions.
Measure and record the dimensions as
shown in Figure 8.
Use dimension “A” to determine total pipe
requirements. Add 12 additional inches to
insure the termination is an adequate distance
above the rooine.
The gross pipe required will be “A”
dimension plus 12 inches. Five feet of this will
be Flex Pipe. The remainder will be rigid pipe.
For each joint, subtract 1-1/ 2 inches to allow
for the overlap. You may need extra pipe, or an
adjustable length pipe section to achieve the
correct height.
Assemble the rst rigid pipe section to the
Flex Pipe, insuring that the “UP” arrows
shown on the pipe labels are, in fact, pointing
up. Push the sections together and twist to
lock. Screws are not required for a rm lock,
however, should it be desired to use them, use
stainless steel sheet metal screws 1/4-inch
long - DO NOT penetrate the inner liner of the
pipe.
Repeat this process for the remainder of the
pipe sections, and lower the assembly down
the chimney as shown in Figure 9. Lower it
below its normal position in order to connect
the Flex Pipe to the pipe on the appliance.
It may be necessary to tie a line to the top
section, to pull it back up later.
In making the connection at the appliance,
congurations other than the one shown in
Figure 10 may be made. It may be necessary
to contact the manufacturer of the unit to
determine exactly what may or may not be
done to make the correct connection. Some
typical arrangements are shown in Figures
11 and 12. A Pipe Adapter may be needed,
depending on the exit size of the stove or
insert collar.
If a Tee is necessary to make the
connection, as shown in Figure 12, the Tee
has a removable Clean Out Adapter on its
base to enable cleaning. The Tee Support
Bracket to hold the Tee to the rear of the
appliance is mandatory. If it is desired to mount
the Tee Support to the rear of the stove, obtain
12 INCHES TO
END OF PIPE
B
C
A
TOP VIEW