Specifications

RADIO SYSTEM CHECK
• Turn the transmitter on, then turn the receiver on.
• Turn the transmitter wheel to the right—the front wheels should turn to the right. If not, move the steering servo reverse switch.
• When running, adjust the steering trim so the truck tracks straight.
• Pull the throttle trigger to make sure the carburetor opens fully and the throttle linkage functions properly without binding.
• Adjust the throttle trim until the carb is at the idle position. Always adjust idle speed with the idle stop screw on the carb, not
the throttle trim..
• Push the trigger and roll the truck to make sure the brakes are applied.
• To shift the Warhead EVO from forward to reverse, flip the toggle switch to the opposite position.
• IMPORTANT! Before shifting from forward to reverse or reverse to forward, bring the truck to a complete
stop.
!
CHECK THE RADIO SYSTEM
FOR PROPER FUNCTION
BEFORE EACH RUN
BODY INSTALLATION
• TIP! Cut out the rear window for
easy access to the rollbar/handle.
• TIP! Adjust your body mounts high
to achieve that “monster” look.
• Decal the body to your liking.
Use the photos on the box as
a reference.
• Install the body onto the
chassis using four body clips.
6