Specifications

6
❏ 1. Remove the Axis buggy and the transmitter from
the box.
❏ 2. Remove the radio tray from the chassis by
removing the (8) 3x15mm flat head self tapping
screws from the bottom of the chassis.
❏ 3. Install the receiver on/off switch. Remove the two
screws from the face plate of the on/off switch and
remove the face plate. The switch should be in the
“OFF” position. Insert the on/off switch up through the
bottom of the radio plate. Then place the face plate
over the top of the on/off switch and place the two
screws back through the face plate into the on/off
switch. Be sure to reinstall the face plate with the
“OFF” position next to the switch button. Run both
wires from the on/off switch through the hole in the
side of the radio box.
RADIO INSTALLATION
ASSEMBLY OF THE AXIS PRE-BUILT VERSION (DTXC0070)
1. Install the batteries in the transmitter and
the receiver battery holders.
2. Extend the transmitter antenna.
3. Connect the steering servo, throttle servo
and receiver battery to the receiver.
4. Extend the receiver antenna.
5. Adjust the servo trims of the transmitter to
the neutral position.
6. Switch on the transmitter.
7. Switch on the receiver.
8. Operate the steering and throttle control.
Make sure the servo arms move in
proportion to the movement of the
steering wheel and throttle trigger.
9. Switch off the receiver, then the transmitter.
Before installing the radio system in the
pre-built DuraTrax Axis read the
manufacturer’s instructions manual and
follow the instructions shown below.
Servo Arm
Steering
Servo
Throttle Servo
Receiver Battery Holder
4-AA Batteries
Transmitter
5
6
1
Antenna
4
8-AA Batteries
1
Receiver
3
Receiver
Switch
7
Antenna
2
8
PREPARING THE RADIO SYSTEM