Specifications

❏ 7. Remove the receiver battery holder from the

radio box. Install (4) “AA” batteries (included) into the

battery holder in the configuration molded into the

battery holder.

❏ 8. Re-install the receiver battery into the radio box.

Note the placement of the receiver battery in the box.

Make sure that the receiver switch is in the “off”

position. Plug the connector on the receiver battery

into the socket on the receiver switch. Wrap the

receiver with the included foam rubber (if desired,

secure with a rubber band, not included) to help

reduce possible radio interference from vibration.

❏ 9. Remove the transmitter antenna from the holder

and screw it into the hole on top of the transmitter.

❏ 10. Slide open the battery door on the bottom of the

transmitter and remove the transmitter battery holder.

Place 8 “AA” batteries (included) into the holder in the

configuration molded into the plastic on the battery

holder. Re-install the transmitter battery holder into the

transmitter and re-install the battery door.

❏ 11. Turn on the transmitter using the switch on the

back (see photo with step 9). The green light on the side

of the transmitter should light up. If there is no light on,

turn the transmitter off and check to ensure that the

battery holder is making contact with the copper contact

on the inside of the battery compartment. Make sure the

batteries are installed correctly. Turn the transmitter on

and check for the green indicator light. If the green light

appears, turn off the transmitter.

❏ 12. Remove the plastic from the outside of the body.

Apply the decals to the body and wing if desired.

❏ 13. Remove the body clips from the parts bag.

Place the body onto the body mounts. On each body

mount place a body clip.

You are ready to go! Watch the video one more time and

turn to page 15 for performance and maintenance tips.

RADIO SETUP